Sentora SSL install problem

[bl4cksta]

Hi all,

I've tried to install my own ssl certificate (premium ssl - comodo) for 5 days.I know there are many different ways to install ssl but I've tried many of them and both side has got an error.Firstly, I've tried to add my certificates from sentora panel after that I've tried to add them to ssl.conf file manually.

Are there any working example or tutorial about them?

Thanks and best regards.
Kaan

[Me.B]

Check how to section!

[clu55ter]

Take a look at this article.
http://blogs.tanertemel.co.uk/2015/04/en...ecure.html

[Ubiquitous]

Take a look at this article.
http://blogs.tanertemel.co.uk/2015/04/en...ecure.html

That was indeed a very clear and useful post. But the httpd fails to restart and complains about the port is busy. I have encountered this before when 2 configs on the system were both listening on port 443,

Code:

-- Unit httpd.service has begun starting up.
May 24 15:53:26 panel.xxxxxxxx.net httpd[4420]: (98)Address already in use: AH00072: make_sock: could not bind to address [::]:443
May 24 15:53:26 panel.xxxxxxxx.net systemd[1]: httpd.service: main process exited, code=exited, status=1/FAILURE
May 24 15:53:26 panel.xxxxxxxx.net kill[4421]: kill: cannot find process ""
May 24 15:53:26 panel.xxxxxxxx.net systemd[1]: httpd.service: control process exited, code=exited status=1
May 24 15:53:26 panel.xxxxxxxx.net systemd[1]: Failed to start The Apache HTTP Server.

But now I can't figure out what is causing this problem. netstat -tulpn does not show port 443 open when httpd service is stopped (duh), so somehow it must be trying to open the port twice. The httpd service spins up when I bring back the original httpd-vhost.conf file and fail again when overwriting it from the Sentora Apache module.

Sentora is installed in panel.mydomain.com, and the SSL-cert is for mydomain.com, which I also choose to "Override a Virtual Host setting". I have tried to point to the SSL-cert in the httpd's ssl.conf, but then it fails to go to the correct home dir of the domain. Port 80 goes fine to mydomain.com/index.html but the SSL on port 443 only goes to the Apache default page.  

Any ideas?

UPDATE:
I commented out the listening on port 443 in /etc/httpd/conf.d/ssl.conf and it stopped complaining about open ports, and instead gave me this quite plain error message

Code:

May 24 16:51:51 panel.xxxxxxxx.net systemd[1]: Starting The Apache HTTP Server...
May 24 16:51:51 panel.xxxxxxxx.net systemd[1]: httpd.service: main process exited, code=exited, status=1/FAILURE
May 24 16:51:51 panel.xxxxxxxx.net kill[5412]: kill: cannot find process ""
May 24 16:51:51 panel.xxxxxxxx.net systemd[1]: httpd.service: control process exited, code=exited status=1
May 24 16:51:51 panel.xxxxxxxx.net systemd[1]: Failed to start The Apache HTTP Server.
May 24 16:51:51 panel.xxxxxxxx.net systemd[1]: Unit httpd.service entered failed state.

UPDATE 2:
Ok I just discovered that https://www.mydomain.com brings the browser to the correct public_html, but https://mydomain.com brings up the Apache default page. This is so wierd.